Dosing Distributors
MV-20: MV-20: In form of a block distributor you can find an air+oil-mixing valve. They are available with up to eight lubricant outlets. For every lubricating point there ist the possibility to adjust the dosage from 0,01 tp 0,16 cm³. If you do not need one of the lubricant outlet you can just close the outlet with special dosing screw by putting it into the dosing distributor. Hereby is an air adjusting screw inclusive. Therefore the screw is to regulate the amount of compressed air. If more than eight lubricating points are needed, you simply add a different dosing distributor. However, compressed air has to be supplied to each valve seperately. |
![]() |
Vogel MV-20 dosing distributor - oil + air - 5°C to 80°C
- Dosing distributor MV-20
- Sealing: NBR or FPM
- Actuation pressure, air: 3 to 10 bar
- Actuation pressure, oil: 17 to 40 bar
- Temperature range: 5°C to 80°C
- Mounting position: any
Vogel MV-50 dosing distributor - oil + air - 40-200mm²/s
- Dosing distributor MV-50
- Sealing: FPM
- Actuation pressure, air: 3 to 10 bar
- Actuation pressure, oil: 25 to 40 bar
- Temperature range: 5°C to 80°C
- Operating viscosity: 40-200 mm²/s
Show 1 to 2 (of in total 2 products) | Sites: 1 |